
The 30-second answer: Size the generator for the pump’s starting watts, not its running watts. Read the pump’s label for the horsepower and the voltage, add the other loads you’ll run, and make sure the total starting load fits the generator’s rating. A generator that runs the pump but stalls when it kicks on is undersized.
Watch: “How to Size a Sump Pump” by Power Equipment Direct on YouTube. A short explainer on sizing a generator for a sump pump. Check the pump’s own label for the figures that matter.
A sump pump is one of the loads people most often get wrong. It sits in a basement for months, then turns on in a storm, when the generator is the only power on the property. The pump’s motor needs a burst of power to start, and the generator has to deliver that burst on top of anything else that’s running.
Why Running Watts Aren’t Enough
A motor draws more current when it starts than when it runs. The extra draw is called starting surge, and it can be several times the running load for a moment. The generator has to handle that surge, or the engine bogs down, the voltage drops, and the pump may fail to start. The starting watts vs. running watts guide explains the math in more detail.
Read the Pump’s Label
Start with the label on the pump motor or its box. Look for the horsepower, the voltage, and the amps. The amps and voltage give you the running watts. Starting watts depend on the motor, and manufacturers often publish them on the box or in the spec sheet. If you can’t find a starting figure, ask the pump maker or your dealer, and use a generator with plenty of headroom rather than guessing.
Add the Other Loads
A sump pump rarely runs alone during an outage. The fridge, a furnace blower, a sump backup, and a few lights all draw power at the same time. Add up the running watts of everything you plan to run, then add the single largest starting surge on top. The result is the load the generator has to carry for a moment.
Compare that number with the generator’s rated running watts and its surge rating. If the total is close to the rating, step up a size. The wattage sizing guide has the full method.
Don’t Run the Pump Through a Long Extension Cord
A thin extension cord adds resistance, which drops voltage at the pump. A motor on low voltage struggles to start and can overheat. Use a cord rated for the pump’s amps and keep it as short as practical. The extension cord guide gives the sizing basics.
Test It Before the Storm
Run the pump on the generator with the other loads you plan to use, and watch what happens. The pump should start on the first try, and the engine shouldn’t bog or the lights shouldn’t dip. If the pump stalls, reduce the other loads, step up to a larger generator, or check the pump’s start capacitor and the wiring. The output test shows how to measure voltage at the outlet under load.
Never connect a sump pump to a generator through a house outlet without a transfer switch or interlock kit. Back-feeding the house wiring can injure utility workers and damage the generator. Read the transfer switch vs. interlock guide before you wire anything in.
Frequently Asked Questions
Can a small generator run a sump pump?
Sometimes. A small unit can run a small pump by itself, but it often fails once the fridge or other loads are added. Do the math with the starting surge before you rely on it.
Why does the sump pump motor hum but not start?
The motor isn’t getting enough voltage or enough starting current. Check the generator’s output under load, reduce other loads, and check the pump’s start capacitor and cord.
Should I use a battery backup pump instead?
A battery backup pump is a good second layer, but it has a limited run time. Many homes use both, with the generator running the main pump.
